2008 Arctic Cat 366 ATV Service Manual, Page 55Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 55

4Install the cam stopper assembly5Install the gear shift shaft assembly and washer making sure to align the alignment marks
the crankshaftTighten the nut to 107 ft-lbCCover 2Install the starter motor and tighten the two cap screws securely3Install
the shift detent cam making sure the spacer is properly positioned NOTE: Steps 1-7 in the preceding sub-section must precede
this procedure 8Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting
the different-lengthed mm cap screws, the position of the shifter bracket, and the location of the long cap screw with the