2008 Arctic Cat 366 ATV Service Manual, Page 59Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 59

18Remove the snap ring holding the oil pump driven gear 21Remove the four cap screws securing the oil strainer cover; then
the pin AT THIS POINT To service clutch components, see Right-Side Components sub-sectionServicing AT THIS POINT To service
center crankcase components only, proceed to Separating Crankcase Halves HOil PumpOil Strainer NOTE: Steps 1-19 in the preceding
sub-sections must precede this procedure 20Remove three Phillips-head screws holding the oil pump and remove the oil pumpAccount