2008 Arctic Cat 366 ATV Service Manual, Page 63Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 63

14Slide the fixed drive face assembly onto the front shaft15Spread the faces of the driven pulley by threading V-belt cover
place new V-belt cover gasket into position on the clutch coverInstall the V-belt cover noting the position of the long cap
screws and rubber washer and two wire formsIn crisscross pattern, tighten cap screws to ft-lb 17Coat the threads of the nut
with red Loctite #271; then making sure the splines of the clutch shaft protrude through the cover plate, secure with the
nut and tighten to 147 ft-lb Center Crankcase Components NOTE: This procedure cannot be done with the enginetransmission
in the frameComplete Removing procedures for Top-Side, Left-Side, and Right-Side must precede this procedureNOTE: For efficiency,
it is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe