2008 Arctic Cat 366 ATV Service Manual, Page 68Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 68

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable
for the bushing and bearing4Remove the washer; then remove the circlip securing the sliding dogRemove the sliding dog ATV-1074
3Zero the indicator and rotate the crankshaft slowly 5Remove the high driven gear circlip; then remove the high driven gearAccount
for the washer, bushing, and bearingAssembling 1Place the high driven gear onto the countershaft making sure the bearing,
bushing, and washer are properly positionedSecure with the circlip2Place the sliding dog onto the countershaft; then secure
with the circlipPlace the washer next to the circlip3Place the low driven gear onto the countershaft making sure the bearing
and bushing are properly positioned; then place the washer onto the shaft4Place the reverse driven gear onto the countershaft
making sure the bearing, bushing, and washer are properly positioned; then secure with the circlip5Place the reverse driven