2008 Arctic Cat 366 ATV Service Manual, Page 71Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 71

Joining Crankcase Halves 1Verify that the two alignment pins are in place and that both case halves are clean and grease
Rotate the shafts back and forth to ensure no binding or sticking occurs while tightening the cap screws NOTE: Rotate the
shafts back and forth to ensure no binding or sticking occurs AT THIS POINT After completing center crankcase components,
proceed to Installing Right-Side Components, to Installing Left-Side Components, and to Installing Top-Side Components Installing
EngineTransmission 1From the right side, place the enginetransmission into the frame tilting the top-side forward to clear
the frame member 4From the left side, install the remaining crankcase cap screws; then tighten only until snugNOTE: Rotate
the shafts back and forth to ensure no binding or sticking occurs while tightening the cap screwsKC216 2Install the front