2008 Arctic Cat 366 ATV Service Manual, Page 89Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 89

Brakelight Switch (Pressure) The brakelight switch is located on the top of the auxiliary brake master cylinder and is pressure
the black tester lead to ground3The meter must show battery voltageNOTE: If the meter shows no battery voltage, troubleshoot
the battery, fuse, switch, or the main wiring harnessNOTE: If the meter shows battery voltage, the main wiring harness is
good; proceed to test the switchcomponent or connector ! WARNING Wear insulated gloves and safety glassesHeated oil can cause
severe burns RESISTANCE (Switch) ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging
the multimeter 1Remove the spade connectors from the brake switch2Set the meter selector to the OHMS position3Connect the
red tester lead to one switch terminal; then connect the black tester lead to the other switch terminal 733-554C 3On the
oil temperature switch when the oil temperature reaches 160 (320 F), the meter should read closed circuit4On the oil temperature