2008 Arctic Cat 366 ATV Service Manual, Page 91Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 91

NOTE: When testing the HI fuse holder, the headlight dimmer switch must be in the HI position; when testing the LIGHTS fuse
to their proper position according to amperageRefer to the fuse block cover for fuse placementAR603D 2The meter reading must
be within specificationNOTE: If the meter does not read as specified, replace the spark plug cap PEAK VOLTAGE Ignition Coil
The ignition coil is on the frame above the engineTo access the coil, the left side panel must be removedRESISTANCE NOTE:
All of the peak voltage tests should be made using the Fluke Model 73 Multimeter with Peak Voltage Reading AdapterIf any
other type of tester is used, readings may vary due to internal circuitryNOTE: The battery must be at full charge for these
tests ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the multimeter PrimaryCDI
NOTE: The CDI is located on the electrical tray in front of the steering shaft NOTE: For these tests, the meter selector
should be set to the OHMS position and the primary wire(s) should be disconnected Primary Winding 1Connect the red tester