2008 Arctic Cat 366 ATV Service Manual, Page 93Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 93

RESISTANCE RESISTANCE (HI Beam) 1Set the meter selector to the OHMS position2Connect one tester lead to the brownblack wire;
switch to the LIGHTS positionThe meter must show less than ohm6Leaving the tester lead on pin B, connect the other tester
lead to pin C7The meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, replace the switch RESISTANCE
(Emergency Stop) 1Set the meter selector to the OHMS position2Connect the one lead to the brownlavender wire; then connect
the other tester lead to the blackwhite wire3With the switch in the OFF position, the meter must show an open circuit4With
the switch in the RUN position, the meter must show less than ohmNOTE: If the meter shows more than ohm of resistance, replace
the switch RESISTANCE (Reverse Override) 1Set the meter selector to the OHMS position Handlebar Control Switches The connectors
are located on the right side of the ATV next to the PDMTo access the connector, the electrical cover must be removedNOTE: