2008 Arctic Cat 366 ATV Service Manual, Page 94Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 94

NOTE: Resistance tests should be made with the connector disconnected and on the selector-side of the connector VOLTAGE 1Select
the one tester lead to the brownlavender wire; then connect the other tester lead to the whitelavender wire3With the selector
switch in the 2WD position, the meter must show less than ohm4With the selector switch in the 4WD position, the meter must
show an open circuitNOTE: If the meter does not show as specified, replace the front drive selector switch VOLTAGE NOTE:
The battery must be connected when performing voltage tests 6Connect the red tester lead to the brownlavender wire in the
supply harnessThe meter must show 12 DC voltsNOTE: If the voltage readings are as specified and the actuator does not function
correctly, replace the actuator (see Section 6) 1Set the meter selector to the DC Voltage position2Connect the black tester
lead to the negative battery terminal3Connect the red tester lead to the brownlavender wire on the harness side of the connector4Turn