2008 Arctic Cat 366 ATV Service Manual, Page 95Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 95

2Select the OHMS position on the tester and connect the red tester lead to the lavenderred wire; then move the gear shift
black tester lead to the negative battery post3With the engine running at constant 3000 RPM (with the headlights on), the
meter must show 14-15.5 DC volts ! CAUTION Always disconnect the battery when performing resistance tests to avoid damaging
the multimeter 1Disconnect the gray four-pin connector on the right side of the engine just above the starter motor2Set the
meter selector to the OHMS position3Connect the red tester lead to the green wire; then connect the black tester lead to
the blue wireThe meter reading must be within specificationPEAK VOLTAGE NOTE: All of the peak voltage tests should be made
using the Fluke Model 73 Multimeter with Peak Voltage Reading AdapterIf any other type of tester is used, readings may vary
due to internal circuitryNOTE: The battery must be at full charge for these tests ! CAUTION Do not run the engine at high
RPM for more than 10 seconds NOTE: If voltage is lower than specified, test charging coilno load VOLTAGE (Charging CoilNo