2008 Arctic Cat 366 ATV Service Manual, Page 96Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 96

NOTE: Make sure that the ignition switch is in the ON position, transmission in neutral, brake lock released, and the emergency
then remove the starterAccount for an O-ringINSTALLING 1Apply small amount of grease to the O-ring seal on the starter; then
install the starter into the crankcaseSecure with two cap screws making sure the engine ground is secured by the rear cap
screwsTighten to ft-lb Starter Motor NOTE: The starter is non-serviceable componentIf the following test does not result
as specified, the starter must be replaced TESTING VOLTAGE Perform this test on the starter motor positive terminalTo access
the terminal, slide the boot awayNOTE: The ignition switch must be in the ON position, the emergency stop switch in the RUN
position, and the shift lever in the NEUTRAL position 1Set the meter selector to the DC Voltage position2Connect the red
tester lead to the starter terminal; then connect the black tester lead to ground3With the starter button depressed, the
meter must show approximately 10.0 DC volts and the starter motor should operate 2Secure the positive cable to the starter