2008 Arctic Cat 366 ATV Service Manual, Page 97Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 97

NOTE: Prior to replacing the CDI unit to assure the CDI unit is defective, it is advisable to perform CDI peak voltage test
Load) in this sectionIf charging coil voltage is normal, replace the regulatorrectifierKC223 VOLTAGE NOTE: Perform this test
on the main harness side of the connectorsAlso, the ignition switch must be in the LIGHTS position 1Set the meter selector
to the DC Voltage position Neutral Start Front Drive Actuator Start-in-Gear 2WD Relays The relays are identical plug-in type
located on the power distribution moduleRelay function can be checked by switching relay positionsThe relays are interchangeableNOTE:
The module and wiring harness are not serviceable component and must be replaced as an assembly 2Connect the black tester
lead to the black wire; then connect the red tester lead to the white wire3With the dimmer switch in the LO position, the
meter must show battery voltage4Remove the red tester lead from the white wire and connect to the lavender wire5With the