2008 Arctic Cat 366 ATV Service Manual, Page 98Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 98

1Set the meter selector to the DC Voltage position2Connect the black tester lead to the black wire; then connect the red
Lights The two running lights use the same connectors as the headlights (see Headlights in this section)VOLTAGE 1Release
the wire connector from the frame; then release and separate the connectorsNOTE: Perform this test on the wiring harness
side of the connectorsKC280 VOLTAGE 1Release the wire connectors from the frame; then disconnect the connectorsNOTE: Perform
this test on the main harness side of the connectors 2Connect the black tester lead of the meter to the black wire; then
with the tester in the DC Volts position, connect the red tester lead to the brownblack wire3Turn the ignition switch to
the LIGHTS positionThe meter must show battery voltageNOTE: If the meter does not show voltage, inspect the LIGHTS fuse,
battery connections, or troubleshoot the main wiring harness 2Connect the black tester lead to the brownlavender wire; then
connect the red tester lead to the lavenderred wire3Set the tester to DC VOLTS; then turn the ignition switch to the ON position