2008 Arctic Cat 366 ATV Service Manual, Page 102Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 102

SPECIAL TOOLS Drive System NOTE: Some photographs and illustrations used in this section are used for clarity purposes only
3.1:1 gear set ratio (11:34 teeth)The die-cast aluminum housings have been assembled with thread-rolling screws (trilobular)When
assembling with these screws, start the screws carefully into the housing; then use the following torque valuesSize M6 (Torx
T-30 Recess) M8 (Torx T-40 Recess) M10 (Torx T-50 Recess) Front Drive Actuator NOTE: The actuator is not serviceable componentIf
it is defective, it must be replacedNOTE: The actuator will operate only when the ignition switch is in the ON position New
Housing 8-9.5 ft-lb 25-31 ft-lb 37-45.5 ft-lb Reassembled Housing 6.5-9 ft-lb 21-25 ft-lb 31-38 ft-lb The front drive actuator
is located on the side of the front drive input housingWith the engine stopped and the ignition switch in the ON position,
momentary "whirring" sound can be heard each time the front drive selector switch is shiftedIf no sound is heard, see Section