2008 Arctic Cat 366 ATV Service Manual, Page 103Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 103

4Loosen but do not remove the mounting cap screw at the front of the actuator; then slide the actuator to the rear enough
ensure proper seating of the actuator 5Tighten the remaining cap screws; then connect the electrical plug to the main harness6Turn
the ignition switch to the ON position and check the operation by shifting the selector switch several times7Secure the wiring
harness to the frame with nylon cable tie Front Differential REMOVING DIFFERENTIAL 1Secure the ATV on support stand to elevate
the wheels ! WARNING 3While holding the actuator firmly forward, tighten the front cap screw to hold the actuator in place;
then install but do not tighten the two remaining cap screws Make sure the ATV is solidly supported on the support stand