2008 Arctic Cat 366 ATV Service Manual, Page 107Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 107

1Remove the cap screws securing the pinion housingAccount for the coupler, fork, and spring KX222 4Install the input shaft
the pinion housing with new gasket onto the gear case housing; then secure with the existing cap screwsTighten to 23 ft-lbNOTE:
If new gear case housing is being installed, tighten the cap screws to 28 ft-lb 3Using plastic mallet, tap lightly to remove
the differential coverAccount for an O-ringNOTE: If the cover is difficult to remove, pry on the cover in more than one recessed