2008 Arctic Cat 366 ATV Service Manual, Page 109Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 109

NOTE: If gears are being replaced, use the existing shimsThe numbers are scribed onto the gears: the ring gear has the number
to final assembling, apply molybdenum disulfide grease to all oil seal lips5Prior to final assembling, prelubricate journal
on pinion assembly with SAE 80W-90 hypoid gear lubricant prior to pressing assembly into gear case housingAssembling Pinion
Gear 1Install the bearing onto the pinion shaftInstall the pinion shaft collar Shimming ProcedureShim Selection 1Press bearings
into bores by outer ring to hard contact with seat2Install the lock collar and tighten to 125 ft-lb; then on final assembling,
stake the lock collar edge approximately 1.5 mm into the lower oil channel CC882 CC891 3Note the following shim selections
(shims are nominally 1.5 mm thick): 2Place the pinion assembly in bearing puller; then install the bearing using press738-268C