2008 Arctic Cat 366 ATV Service Manual, Page 111Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 111

8Install the proper shim onto the ring gear spider assembly making sure the chamfer side of the shim is facing toward the
hardwareAccount for the ID tagTighten the cap screws to 23 ft-lbNOTE: Grease can be applied to the O-ring for ease of assemblingNOTE:
If new gear case housing is being installed, tighten the cap screws to 25-31 ft-lb Removing Needle Bearing NOTE: Removing
the needle bearing is rarely necessaryAvoid removing the needle bearing unless the bearing is clearly damagedNOTE: This procedure
can be performed on rear gear case 1Place 14 indrill bit on the inside surface of the needle bearing (against the bottom