2008 Arctic Cat 366 ATV Service Manual, Page 116Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 116

NOTE: The recess of the bearing must face toward the housing 8Apply 40 grams (13 of contents) of grease from the Grease Pack
requires approximately 35-55 gramsWhen replacing boots, use 23 of the pack for inside boots and 13 of the pack for outside
boots ! CAUTION Do no over-fill the joint as boot damage may occur resulting in joint failure 9Slide the new outside boot
onto the shaft with the new clamps positioned as shownNote the different-sized clamps from removalNOTE: The boot is positioned
correctly when the small end of the boot seats down into the recessed grooveCD752 NOTE: At this point if the outside boot
is damaged, continue with step 7 7Using side-cutters (or suitable substitute), remove both outside boot clamps from the shaftNote