2008 Arctic Cat 366 ATV Service Manual, Page 117Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 117

ASSEMBLING AXLES 1Install the inner boot with the small clamp making sure the ends of the clamp are positioned correctlyNOTE:
CD023 2Using the boot clamp pliers, secure the small clamp of the inner boot 6Making sure the marks made during disassembling
align, slide the housing over the bearing ring; then completely seat the bearing ring into the housing and install the circlipNOTE:
Pull the bearing ring out of the housing until it contacts the circlip; then slide the ring in half wayThis will purge air
from the housing and ensure the bearing is packed properly ATV-1048 3Apply 80 grams (23 of contents) of grease from the pack