2008 Arctic Cat 366 ATV Service Manual, Page 118Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 118

4Tighten the hub hex nut (from step 2) to 200 ft-lb; then install and spread new cotter pin making sure each side of the
on the knuckle and secure with existing cap screwsTighten the brake caliper cap screws to 20 ft-lb5Pump up the hand brake
lever; then engage the brake lever lock6Tighten the hub hex nut (from step 3) to 200 ft-lb; then install and spread new cotter
pin making sure each side of the pin is flush to the hub nut7Install the wheelTighten to 40 ft-lb8Remove the ATV from the
support stand and release the brake lever lockINSTALLING FRONT DRIVE AXLE 1Position the drive axle in the gear case and steering
knuckle; then insert the upper A-arm ball joint into the steering knuckleSecure with cap screw tightened to 35 ft-lb2Slide
the hub wbrake disc into position in the steering knuckle followed by washer and hex nutTighten finger-tight at this time3Install
the brake caliper on the steering knuckleTighten to 20 ft-lb; then pump up the hand brake lever and engage the brake lever