2008 Arctic Cat 366 ATV Service Manual, Page 119Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 119

Hub REMOVING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel ! WARNING 3Remove the two cap screws
to 45 ft-lb2Secure the engine output shaft to the rear gear case input flange with four cap screws (coated with red Loctite
#271) and lock nutsTighten to 20 ft-lb3Install the rear drive axles (see Drive Axles in this section) 5Remove the hub assembly6Remove
the four cap screws securing the brake discCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged
in any way, replacement is necessary 1Clean all hub components2Inspect all threads for stripping or damage3Inspect the brake
disc for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING 1Secure the brake disc