2008 Arctic Cat 366 ATV Service Manual, Page 120Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 120

3Install the hub assembly onto the shaft4Secure the hub assembly with the nutTighten only until snug5Secure the brake caliper
4) to 200 ft-lb; then install and spread new cotter pin making sure each side of the pin is flush to the hub nut 7Install
the wheel and tighten to 40 ft-lb8Remove the ATV from the support standPR238 Hydraulic Brake Caliper NOTE: The brake calliper
is non-serviceable component; it must be replaced as an assembly 5Remove the caliper holder from the caliper and account
for the brake caliper O-ringDo not remove the piston from the caliper REMOVINGDISASSEMBLING 1Secure the ATV on support stand