2008 Arctic Cat 366 ATV Service Manual, Page 125Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 125

5Install the knuckle assembly onto the ball joints and secure with cap screwsTighten to 35 ft-lb6Apply grease to the hub
components using pressure washer2Clean the ball joint mounting hole of all residual Loctite, grease, oil, or dirt for installing
purposes3Inspect the A-arm for bends, cracks, and worn bushings4Inspect the ball joint mounting holes for cracks or damage5Inspect
the frame mounts for signs of damage, wear, or weldment damageINSTALLING 1Apply green Loctite #609 to the entire outside
diameter of the ball joint; then install the ball joint into the A-arm and secure with the circlip2Install the A-arm assemblies
into the frame mounts and secure with the cap screwsOnly finger-tighten at this time3Secure the lower eyelet of the shock
absorber to the upper A-armTighten nut to 35 ft-lb4Secure the A-arm assemblies to the frame mounts (from step 2)Tighten the
cap screws to 35 ft-lb ! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 2Pump up the