2008 Arctic Cat 366 ATV Service Manual, Page 126Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 126

6Secure the brake caliper to the knuckle with the two cap screws (right side only)Tighten the caliper to 20 ft-lb7Compress
remove the A-armsNOTE: If removing the upper right A-arm, it will be necessary to disconnect the brake hose from the A-arm
Wheels and Tires KEY 1234567891011 CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in
any way, replacement is necessary 1Clean all A-arm components using pressure washer2Inspect the A-arm for bends, cracks,
and worn bushings3Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING 1Install the A-arm assemblies
into the frame mounts and secure with the cap screws and new lock nutsOnly finger-tighten at this time2Slide the knuckle
onto the drive axle and into position on the A-arms; then secure the knuckle to the A-arms with cap screws and new lock nutsTighten
to 35 ft-lb3Tighten the hardware securing the A-arms to the frame mounts (from step 1) to 35 ft-lb4Apply grease on the drive