2008 Arctic Cat 366 ATV Service Manual, Page 127Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 127

TIRE INFLATION PRESSURE Front and rear tire inflation pressure should be 0.28 kgcm (4.0 psi)REMOVING 1Secure the ATV on support
lugs, and leaksINSTALLING Install each wheel on its hubTighten to 40 ft-lbNOTE: Make sure each wheel is installed on its
proper hub as noted in removing (the "rotation arrow" (if applicable) must indicate forward direction of rotation) NOTE:
If repair is needed, follow the instructions found on the tire repair kit or remove the wheel and have it repaired professionallyNOTE:
Be sure all tires are the specified size and have identical tread pattern 3Check the front wheel toe-in and toe-out and adjust
as necessary (see Section 8)4Test drive the ATV on dry, level surface and note any pulling to the left or right during acceleration,
deceleration, and brakingNOTE: If pulling is noted, measure the circumference of the front and rear tires on the pulling
sideCompare the measurements with the tires on the opposite sideIf pulling is noted during braking only, check and adjust