2008 Arctic Cat 366 ATV Service Manual, Page 132Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 132

3Using sharp utility knife, split the handlebar grip from end to end and peel off the rubber4Using an adhesive solvent,
Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary ! WARNING Make sure the ATV is
solidly supported on the support stand to avoid injury 1Clean all knuckle components2Inspect the bearing for pits, gouges,
rusting, or premature wear3Inspect the knuckle for cracks, breaks, or porosity4Inspect threads for stripping or damageASSEMBLING
AND INSTALLING 1Install the bearing; then install the snap ring making sure it seats into the knuckle 2Remove the wheel cap
from the hub; then remove the cotter pin from the nut3Remove the nut securing the hub4Remove the brake caliper5Remove the
hub assembly6Remove the cotter pin from the tie rod end and remove the tie rod end from the knuckle7Remove the two cap screws