2008 Arctic Cat 366 ATV Service Manual, Page 134Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 134

6Using permanent marker of some type, mark the center of each front tire (at height parallel to the belly panel) CLEANING
ball joints are at the center of their normal range of motion and at the correct angle 1Place the rack into position on the
frame and front fender panelInstall the cap screws and lock nuts and finger-tighten only2Install the two cap screws and lock
nuts securing the rack to the fendersTighten all hardware securely Front Bumper Assembly REMOVING 1Remove the two front cap
screws securing the front rack to the bumper support tubes; then remove two cap screws and nuts securing the bumper support
tubes to the frame2Remove the through-bolt and lock nut securing the bumper to the frame; then remove the bumperCLEANING
AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Clean all
bumper components with parts-cleaning solvent2Inspect all welds for cracking or bending733-559A INSTALLING 1Place the front
bumper assembly into position and install the through-boltStart the lock nut and finger-tighten only2Install the existing