2008 Arctic Cat 366 ATV Service Manual, Page 141Get this manual

2008 Arctic Cat 366 ATV Service Manual, Page 141

Hand Brake Lever Master Cylinder Assembly NOTE: The master cylinder is non-serviceable component; it must be replaced as
the two machine screws securing the throttle control to the handlebar2Slide the grommet out of the lower half of the throttle
control; then remove the cable from the actuator arm 2Place an absorbent towel around the connection to absorb brake fluidRemove
the banjo-fitting bolt from the master cylinderAccount for two crush washers and banjo-fitting bolt ! CAUTION Brake fluid
is highly corrosiveDo not spill brake fluid on any surface of the ATV 3Remove the cap screw, lock washer, and washer securing
the actuator arm to the throttle control lever 3Remove the clamp screws securing the brake housing to the handlebar, then
remove the assembly from the handlebarINSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
replacement is necessary 1Inspect the pin securing the brake lever for wear2Inspect the brake lever for elongation of the