2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 17Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 17

ValveTappet Clearance (700 EFI) To check and adjust valvetappet clearance, use the following procedureNOTE: The seat, heat
handle with one of the marks on the valve adjuster dial6While holding the valve adjuster handle in place, rotate the valve
adjuster dial counterclockwise until proper valvetappet clearance is attainedNOTE: Refer to the appropriate specifications
in Feeler Gauge Procedure sub-section for the proper valvetappet clearanceNOTE: Rotating the valve adjuster dial counterclockwise
will open the valvetappet clearance by 0.05 mm (0.002 in per mark 2Remove the recoil starter assembly; then remove the valve
timing inspection plug and the cylinder head cover 3Using an appropriate bar, rotate the engine through two full revolutions;
then while on the compression stroke, align the TDC line on the starter clutch with the index mark on the crankcase 7While
holding the adjuster dial at the proper clearance setting, tighten the jam nut securely with the valve adjuster handle8Place