2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 23Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 23

AT THIS POINT To checkservice oil strainer, see Section 3 3Drain the oil into drain pan by removing in turn the drain plug
drive filler plug; the lubricant level should be inbelow the threads of the plugIf low, add SAE approved 80W-90 hypoid gear
lubricant as necessaryTo change the lubricant, use the following procedure1Place the ATV on level ground2Remove each oil
fill plug 737-651B 4After all the oil has been drained, install the drain plugs and tighten to 45 inlb5Pour the appropriate
amount of approved SAE 80W-90 hypoid gear lubricant into the filler hole6Install the fill plugsNOTE: If the differentialrear
drive oil is contaminated with water, inspect the drain plug, filler plug, andor bladder ! CAUTION Water entering the outer