2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 25Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 25

DriveshaftCoupling The following drive system components should be inspected periodically to ensure proper operationASpline
to the lights position; the headlights and taillight should illuminateTest the brakelight by compressing the brake leverThe
brakelight should illuminateHEADLIGHTS NOTE: The bulb portion of headlight is fragileHANDLE WITH CAREWhen replacing headlight
bulb, do not touch the glass portion of the bulbIf the glass is touched, it must be cleaned with dry cloth before installingSkin
oil residue on the bulb will shorten the life of the bulb ! WARNING Do not attempt to remove bulb when it is hotSevere burns
may result NutsBoltsCap Screws Tighten all nuts, bolts, and cap screwsMake sure rivets holding components together are tightReplace
all loose rivetsCare must be taken that all calibrated nuts, bolts, and cap screws are tightened to specifications (see Section
1) To replace headlight bulb, use the following procedure1Remove the wiring harness connector from the back of the headlight2Grasp