2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 28Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 28

9Shift the transmission into each of the remaining positions and verify that the appropriate icon is displayed for the selected
slowly compress the brake lever several timesCRemove the protective cap, install one end of clear hose onto one FRONT bleeder
screw, and direct the other end into container; then while holding slight pressure on the brake lever, open the bleeder screw
and watch for air bubblesClose the bleeder screw before releasing the brake leverRepeat this procedure until no air bubbles
are present Electrical Connections The electrical connections should be checked periodically for proper functionIn case of
an electrical failure, check fuses, connections (for tightness, corrosion, damage), andor bulbsIf an electrical component
needs to be tested for proper function, see Section 5 Hydraulic Brake Systems CHECKINGBLEEDING The hydraulic brake systems
have been filled and bled at the factoryTo check andor bleed hydraulic brake system, use the following procedure1With the