2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 29Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 29

NOTE: During the bleeding procedure, watch the reservoir sight glass very closely to make sure there is always sufficient
are installed, and no leakage is present ! CAUTION This hydraulic brake system is designed to use DOT brake fluid onlyIf
brake fluid must be added, care must be taken as brake fluid is very corrosive to painted surfacesPR237 CInstall the new
brake padsDSecure the caliper to the knuckle andor axle housing with the cap screwsTighten to 20 ft-lb INSPECTING HOSES Carefully
inspect the hydraulic brake hoses for cracks or other damageIf found, the brake hoses must be replacedCHECKINGREPLACING PADS
The clearance between the brake pads and brake discs is adjusted automatically as the brake pads wearThe only maintenance
that is required is replacement of the brake pads when they show excessive wearCheck the thickness of each of the brake pads
as follows1Remove front wheel2Measure the thickness of each brake pad3If thickness of either brake pad is less than 1.0 mm