2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 30Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 30

Burnishing Brake Pads Brake pads (both hydraulic and auxiliary) must be burnished to achieve full braking effectivenessBraking
the auxiliary brake (if necessary)5Verify that the brakelight illuminates when the hand lever is compressed or the brake
pedal is depressed NOTE: Note the location of the main engine ground wire for installing purposes 3Remove the nut securing
the movable drive face; then remove the faceAccount for the spacer (Liquid Cooled Models) When filling the cooling system,
use premixed Arctic Cat AntifreezeWhile the cooling system is being filled, air pockets may develop; therefore, run the engine
for five minutes after the initial fill, shut the engine off, and then fill the cooling system to the bottom of the stand
pipe in the radiator neck Coolant ! CAUTION After operating the ATV for the initial 5-10 minutes, stop the engine, allow
the engine to cool down, and check the coolant levelAdd coolant as necessary CheckingReplacing V-Belt 4Remove the V-beltREMOVING