2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 31Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 31

NOTE: At this point, the push-bolt can be removed 4Rotate the V-belt and clutches until the V-belt is flush with the top
ground wire is installed and secured in the proper location 6Secure the front fender to the footrest with the two cap screwsTighten
securely7Install the right-side footrest (see Section 8) Adjusting Differential Lock Cable NOTE: The arrow on the V-belt
should point forward 3Pinch the V-belt together near its center and slide the spacer and movable drive face onto the driveshaftSecure
the drive face with nutTighten the nut to 72 ft-lb (400500), 221 ft-lb (H1 Models), or 81 ft-lb (700 EFI) If the differential
or differential lock system has been serviced, the differential lock cable should be checked andor adjusted for proper free-playTo
adjust the cable, use the following procedure1With the differential lock selector in the UNLOCK position, slide the rubber