2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 58Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 58

! CAUTION Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing
readingMaximum trueness (out-of-roundness) must not exceed specificationsCC997 CleaningInspecting Cylinder 1Wash the cylinder
in parts-cleaning solvent2Inspect the cylinder for pitting, scoring, scuffing, warpage, and corrosionIf marks are found,
repair the surface using cylinder hone (see Honing Cylinder in this sub-section)3Place the cylinder on the surface plate
covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder in figure eight motionInspect the sealing
surface for any indication of high spotsA high spot can be noted by bright metallic finishCorrect any high spots before assembly
by continuing to move the cylinder in figure eight motion until uniform bright metallic finish is attainedCC127D 2Wash the