2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 59Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 59

NOTE: To produce the proper 60 cross-hatch pattern, use low RPM drill (600 RPM) at the rate of 30 strokes per minuteIf honing
an oversized piston or replace the cylinderNOTE: Oversized piston and rings are available in 0.50 mm (0.020 in only ATV1013A
2The lobe heights must not exceed minimum specificationsInspecting Camshaft Bearing Journal 1Inspect the bearing journal
for scoring, seizure marks, or pittingCC127D Measuring Camshaft Runout NOTE: If the camshaft is out of tolerance, it must
be replaced 2If excessive scoring, seizure marks, or pitting is found, the cylinder head assembly must be replacedMeasuring
Camshaft to Cylinder Head Clearance 1Remove the adjuster screws and jam nuts 1Place the camshaft on set of blocks; then position