2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 61Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 61

Installing Top-Side Components APiston BCylinder KEY 123456789 Cylinder Stud Bolt Stud Bolt Bolt Bolt Bolt Nut Cylinder Gasket
the expander making sure the expander ends do not overlapStagger the end gaps of the upper and lower thin oil rings according
to the illustrationNOTE: Note the direction of the exhaust side of the piston (5) for correct ring end gap orientation 2Place
the two alignment pins into positionPlace new cylinder gasket into position; then place piston holder (or suitable substitute)
beneath the piston skirt and square the piston in respect to the crankcase ATV-1085B BInstall the compression rings (1 and
2) so the letter on the top surface of each ring faces the dome of the pistonRotate the rings until the ring end gaps are