2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 62Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 62

3Lubricate the inside wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder
routed through the chain cavity ! CAUTION Keep tension on the cam chain to avoid damaging the crankcase boss 4Loosely install
the two nuts with washers which secure the right-side of the cylinder to the right-side crankcase halfNOTE: The two cylinder-to-crankcase
nuts will be tightened in step 9 CCylinder HeadCam Shaft DValve CoverRocker Arms NOTE: Steps 1-4 in the preceding sub-section
must precede this procedure 5While keeping tension on the cam chain, place the chain guide into the cylinder 7Install the
four cylinder head cap screws with washersNote that the two cap screws on the right side of the cylinder head nearest the