2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 67Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 67

NOTE: To aid in installing, it is recommended that the assemblies are kept together and IN ORDER CF109 4Remove the cap screws
install the crankshaft protector 6Using the Magneto Rotor Remover, remove the rotorflywheel assembly from the crankshaftAccount
for the key; then remove the starter clutch gear assembly (H) wwasherCC946 NOTE: Inspect the inside of the left-side cover
for any shaft washers and spacers that may have come off with the coverMake sure they are returned to their respective shaftsAlso,
make sure the alignment pins are in place NOTE: Care must be taken that the remover is threaded all the way onto the rotorflywheel