2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 71Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 71

8Unwind the rope from the reel and remove the ropeCleaning and Inspecting NOTE: Whenever part is worn excessively, cracked,
accidentally disengage from the case ! WARNING Care must be taken when lifting the reel free of the caseWear safety glasses
to avoid injury 6Remove the protective cover from the starter handle and pull the rope out of the handle; then untie the
knot in the rope and remove the handleNOTE: Do not remove the spiral spring unless replacement is necessaryIf replacement
is necessary, follow steps 7-8 2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope
counter- clockwise around the reel leaving approximately 50 cm (20 in of rope free of the reel3Apply low-temperature grease
to the spring and hub4Thread the end of the rope through the guide hole of the case; then thread the rope through the handle
and secure it with double knotInstall the protective cover into the handle5Align the inner hook of the spiral spring with