2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 88Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 88

1Remove the output shaft assembly (J)2Remove the two shift shafts (E and H)3Remove the reverse shift cam (G) and spacer4Disengage
balancer assembly (A)NOTE: When removing the crank balancer assembly, rotate the crankshaft counterweight away from the crank
balancer assembly counterweight AT THIS POINT To service gear shift forks, see Servicing Center Crankcase Components sub-section
7Remove the reverse idle gear (K) wshaftAccount for the bushing, two washers, and the circlip8Simultaneously, remove the
driveshaft assembly (I) and countershaft assembly (D) 11Using an appropriate crankshaft remover, push the crankshaft assembly
(B) out of the crankcase AT THIS POINT To service the driveshaft andor countershaft, see Servicing Center Crankcase Components