2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 89Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 89

AT THIS POINT To service crankshaft assembly, see Servicing Center Crankcase Components sub-section 3Mount the indicator
remove an existing shim, measure it, and install thicker shimNOTE: Continue to remove, measure, and install until backlash
measurement is within toleranceNote the following chartBacklash Measurement Under 0.05 mm (0.002 in Shim Correction Decrease
Shim Thickness Increase Shim Thickness At 0.05-0.33 mm (0.002-0.013 in No Correction Required Over 0.33 mm (0.013 in Servicing
Center Crankcase Components NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance, replacement
is necessary Checking Tooth Contact NOTE: After correcting backlash of the secondary driven bevel gear, it is necessary to
check tooth contact 1Remove the secondary driven output shaft assembly from the left-side crankcase half2Clean the secondary
driven bevel gear teeth of old oil and grease residue3Apply thin, even coat of machinist-layout dye to several teeth of the