2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 102Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 102

9Install the two gear shift fork shafts; then verify that the two crankcase half alignment pins are in placeNOTE: Prior to
tighten to 16 ft-lbCC102D 2Using plastic mallet, lightly tap the case halves together until cap screws can be installed3From
the right side, install the case half mm cap screws; then tighten only until snugNOTE: Rotate the shafts back and forth to
ensure no binding or sticking occurs NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 8In crisscrosscase-to-case
pattern, tighten the mm cap screws (from steps 5-6) to ft-lbNOTE: Rotate the shafts back and forth to ensure no binding or
sticking occurs ! CAUTION After completing center crankcase components, proceed to Installing Right-Side Components, to Installing
Left-Side Components, and to Installing Top-Side Components 4From the left side, install the case half mm cap screws (two