2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 118Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 118

CYLINDERCYLINDER HEAD ASSEMBLY NOTE: If the cylindercylinder head assembly cannot be trued, they must be replaced CleaningInspecting
the cylinder for pitting, scoring, scuffing, warpage, and corrosionIf marks are found, repair the surface using cylinder
hone (see Honing Cylinder in this sub-section)3Place the cylinder on the surface plate covered with #400 grit wet-or-dry
sandpaperUsing light pressure, move the cylinder in figure eight motionInspect the sealing surface for any indication of
high spotsA high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move
the cylinder in figure eight motion until uniform bright metallic finish is attained ! CAUTION Water or parts-cleaning solvent
must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result ! CAUTION Water or
parts-cleaning solvent must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result