2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 119Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 119

Honing Cylinder 1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations
found, repair the surface using ball honeNOTE: To produce the proper 60 cross-hatch pattern, use low RPM drill (600 RPM)
at the rate of 30 strokes per minuteIf honing oil is not available, use lightweight petroleum-based oilThoroughly clean cylinder
after honing using soap and hot waterDry with compressed air; then immediately apply oil to the cylinder boreIf the bore
is severely damaged or gouged, replace the cylinder 2Rotate the camshaft and note runout; maximum tolerance must not exceed
specificationsMeasuring Camshaft Lobe Height 1Using calipers, measure each cam lobe height 4If any measurement exceeds the
limit, bore the cylinder and install an oversized piston or replace the cylinderNOTE: Oversized piston and rings are availableThe