2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 130Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 130

NOTE: The spiral spring must seat evenly in the recoil case B601D 9With the 50 cm (20 in of rope exposed, hook the rope in
the rope out two or three times to check for correct tensionNOTE: Increasing the rotations in step 10 will increase spring
tension Installing Left-Side Components AStarter Idler Gears BRotorFlywheel 1Place the crankshaft bearing retainer into positionApply
red Loctite #271 to the three screwsInstall and tighten the three cap screws securely 6Install the ratchet onto its pin making
sure the end is properly installed on the reel7Install the shaft, spring, and the spring cover; then install the friction
plate with the ratchet guide fiting into the ratchet8While pushing down on the reel, install the nutTighten securelyMD1122