2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 132Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 132

11Tighten the cap screws (from step 9) in crisscross pattern securely12Place the gasket, recoil starter assembly, and cover
information in each sub-sectionMD1307 NOTE: The enginetransmission does not have to be removed from the frame for this procedure
2Mark the movable drive face and the fixed drive face for installing purposes; then remove the nut holding the movable drive
face onto the crankshaft Removing Right-Side Components AV-Belt Cover BDriven Pulley CClutch Cover 1If the engine is still
in the frame, remove the right foot-rest assembly, footwell, and rear body panel (see Section 8)Remove the cap screws securing
the right-side V-belt cover to the clutch coverRemove the coverNote the locations of the long cap screws and the two wire