2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 137Get this manual

2008 Arctic Cat 400/500/650/700 ATV Service Manual, Page 137

2It is inadvisable to remove the screw securing the pump halvesIf the oil pump is damaged, it must be replaced CD067 4Using
the compressor tool base engaging the dowel pins into appropriate holes in the fixed face of the assembly 5Place the holding
handle on the spring holder fitting the two dowel pins into the spring holder face; then install flat washer and the wing
nutTurn the wing nut down until resistance is feltNOTE: Do not use the wing nut to compress the spring further 3Install the
pilot bushing with the machined end directed down; then fit the bushing into the pulley hub ! WARNING The spring assembly
is under pressureExtreme care must be taken when relaxing the springAlways wear safety glassesUse proper tools only 6Using